Hybrid Wire Arc AM for the Oil & Gas Industry


CATEGORY: Industry and Maintenance

MX3D, Team and Tiat reveal 3D printed pipeline clamp. Clamps like these are used in the Chemical and Oil & Gas industries to prevent incidents and to increase the run time of an installation before maintenance is required

MX3D, a Robotic Wire Arc Additive Manufacturing (WAAM) company, successfully completed the printing of an industrial pipeline clamp.


The WAAM Clamp is made and tested in collaboration with Team Industries and TiaT, two companies with extensive experience in the maintenance, testing and (emergency) repair of complex industrial pipe systems. The BWI (Belgium Welding Institute) handled the material testing and Lloyd’s Register supported MX3D with the certification process.


Short lead times are key in the oil and gas industry, as both reducing production downtime and decreasing environmental, human and safety risks are critical. The current lead time of pipeline repair can be as long as 2 to 3 weeks with a potential lost value of several 100k to 1M EUR per day. Current repair processes by clamps typically rely on CNC milling, specialized manual labour, or a combination of both. Each of these processes have their downsides, as CNC milling has high material waste (on average >80% of the original material) and specialized labourers are becoming more scarce.


During the scope of the WAAM Clamp project, a typical repair part for pipelines has been researched and manufactured with hybrid WAAM. This technique provides a smart production solution, by combining the advantages of traditional manufacturing (such as precision machining) with the advantages of wire arc additive manufacturing (such as form freedom, high deposition rates and minimal material waste).


The consortium managed to reach a high level of assurance for the WAAM clamp. BWI tested the materials and confirmed the printed material complied with key TEAM Industries requirements for this material. The MX3D M1 Metal AM System, facility and procedures were qualified by Lloyds Register. TiaT performed non-destructive testing, such as Ultrasonic Testing (UT), Penetrant Testing (PT), Radiographic Testing (RT), showing no relevant defects. TEAM Industries has performed a pressure test, which ran until the maximum pressure of the test installation (i.e. > 60 Bar) without any failure.


The base and printing material used was ASME IIA SA-516-70, a type of steel often used in the Chemical and Oil & Gas industries. The requirements for the mechanical properties of this material were dictated by its most common use case: pressure vessels working at medium to low temperature. The destructive tests were performed following ASTM A370. The destructive testing results proved that the printed material, even in its least favourable direction, has mechanical properties similar or better than the base material, hence fitting the ASME requirements.


The project introduces Hybrid WAAM, a new approach to counter two known disadvantages of additive manufacturing, namely the need for post-processing and precision. While large scale additive manufacturing can produce parts very fast, traditional manufacturing techniques can sometimes still be faster for the production of simple shapes. Conventional techniques can also achieve a higher level of precision than large scale AM. By introducing a hybrid approach, the project consortium used 3D printing only for the most complex geometrical parts of the clamp, while using traditional manufacturing for the simpler parts, saving precious time.




Return to the list